Agri-Fab 45-0405 - Manual (Page 4)

4
ASSEMBLY INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY
(1) Pliers
() 7/16 in. open or boxed end wrenches
1. Remove the spreader, the loose parts and the hardware
package from the carton. Lay out parts and hardware
and identify using the illustrations on pages and 3.
. With the spreader resting upside down on the top of the
hopper, assemble a 5/8 in. flat washer, a spacer and
a second 5/8 in. flat washer onto each end of the axle.
See figure 1.
FIGURE 1
6. Install an upper handle to each lower handle using four
1/4 x 1-1/ in. bolts and nylock nuts. Do not tighten at
this time. See figure 3.
ENGLISH
3. Place a wheel onto each end of the axle. The long end
of the hub goes to the inside. See figure 2.
4. Assemble a 5/3 x in. cotter pin through the hole in
one wheel hub and the axle. See figure 2.
5. Place a 5/8 in. flat washer onto each end of the
axle and secure with a 9/64 x 1-1/ in. cotter pin.
See figure 2.
45_0382Fig3
1/4-20 x 1-1/2 in.
HEX BOLT (B)
1/4-20 NYLOCK
NUT (E)
FIGURE 3
FIGURE 2
45_0382Fig2
5/32 x 2 in.
COTTER PIN (I)
9/64 x 1-1/2 in.
COTTER PIN (J)
5/8 in. FLAT
WASHER (H)
45_0382Fig1
5/8 in. FLAT WASHER (H)
SPACER (N)