ATN PS-22 - Manual (Page 5)

4
5) Slide the PS-22 with Adapter onto the objective of day scope.
6) Tighten hard the fixing screws of the Ring Adapter.
7) Mount the Picatinny Rail Adapter onto the body of PS-22 with 2 screws M4x7 from set.
8) Place the IR Illuminator onto the Picatinny Rail.
Optional Ring Adapters allows to mount unit onto the objective of the day scope
(25...58mm diameter)
Ring Adapter # Diametr of scope lens
(insert size)
Examples of scops
1 25.4 Leupold 1,5-5x20 PR
30 Leupold 1,5-5x20 MR/T M2,
Zeiss 1,1-4x24 T
2 38 Meopta Artemis 2000 4x32
42 Leupold 3-9x36,
Kahles 4x36
3 46.5 Leupold 3,5-10x40
48 Zeiss1,5-6x42,
Swarovski PV-N 2,5-10x42
fro 48.7 to 49.0 Meopta Artemis 3000 3-9x42
49.5 Meopta Artemis 3000 4-12x40
50 Schmidt@Bender 10x42 PMII
4 56 Zeiss 2,5-10x50
57 Schmidt@Bender 3-12x50
58.4 Leupold 4,4-14x50
OPERATION
• Place the PS-22 before objective of daytime scope.
• Put power switch in OFF-position.
• Install the battery into the housing with the polarity order as shown on the devices body. The bat-
tery is 3 volt lithium battery (CR123A).
• Turn the devise on by rotation the power switch into the ON-position. The greenish-lit screen of
the image tube (when looking through the eyepiece) means that the image tube is powered.
Do not turn the unit on in the daytime without the protective lens cap on.
• Next, remove the lens cap.
• Observe the scene and adjust the focusing of PS-22 by rotation the focusing ring. Also focusing
daytime scope for optimal clarity.
• Turn on the illumination of day scope reticle (if it present) and adjust the brightness.
• Put power switch in OFF-position for turn PS-22 off.