Codelocks KL1000 KitLock Locker Lock - Manual (Page 2)

SPECIAL NOTES
• Before installing the lock, load the batteries and familiarise yourself
with the operation and programming.
• The handle will not turn until you enter the factory default
Master Code 66 77 88 99 OR the User Code 11 22.
• Please see programming guide to set your own codes.
INSTALLATION GUIDE
A) Replacing existing cam lock with
the KitLock
Step 1 Remove existing cam lock.
Step 2 Place template over hole left by cam lock and mark
upper fixing hole.
Step 3 Drill the 6mm ( 1 /
4
”) upper fixing hole.
Step 4 Fit the KitLock to the door by passing the spindle
through the 16mm (
5 /
8
”) hole.
Step 5 If required, from the inside of the door, pass either of the
packing pieces over the spindle to centralise the lock.
Step 6 Now secure the lock by threading the large nut onto
the spindle.
Step 7 Fit one of the upper fixing bolts to suit your
door thickness.
Step 8 Tighten the lower fixing nut and upper bolt.
FITTING INSTRUCTIONS
The KitLock can be fitted to:
A) Cupboards, cabinets and lockers etc as a direct replacement for
existing cam locks.
B) It can also be easily fitted to cupboards and cabinets that do not
have an existing locking device.
1 KitLock
2 Upper fixing bolt x 2
3 Packer pieces x 2
4 Locking nut
5 Cams x 2
6 Cam fixing bolt
• Batteries – 2 x 1.5V AAA
• Template x 1
1
2
3 4 5 6