Codelocks CL625 Double Cylinder Mortice Lock - Manual (Page 12)

Step 4
Insert the fire cup into the
54mm (21/8”) hole.
N.B. open side of the fire cup
to face code side with small
bolt through hole at the bottom.
Step 5
Reinsert the latch and fix the
screws, with the bevel towards
the door frame. (See diagram B).
Step 6
Fit the spindles to the latch
according to the hand of your
door. Fit remaining spindle to
inside - non code side.
(see diagram below).
Install the spindle washers
(item 3) over the flat blade of
both spindles. Use enough
washers so they sit flush to
the face of the door without
bind when the Codelock
is installed.
Step 8
Screw the fixing posts
(item 1 on page 13) into the
front plate. Place the outer
cover plate to the door with the
inner cover plate (item 4) using
the three fixing bolts (item 5).
Step 9
Fix the front plate to the door
with the inner cover plate
(item 4) using the three fixing
bolts (item 5). Fit the inside
handle body to the inner cover
plate using the three short fixing
bolts (item 6).
Step 10
Check that the lever handles
are correctly fitted for the
hand of door. To change the
hand of a lever handle,
loosen the grub screw with
the small Allen key, reverse
the lever handle and fully
tighten the grub screw.
Step 11
Before closing the door,
enter the code and ensure
that the latchbolt will retract
when the lever handle is
depressed. Now check the
operation of the inside lever
handle. If there is any binding
of the handles or latch then
loosen the bolts and
reposition the plates slightly
until the correct position is
found, and then re-tighten
the bolts.
12
FIRE KIT INSTALLATION INSTRUCTIONS
Installation holes must be drilled
in exactly the correct positions
and precisely at right angles to
the door surface. Lock
components must be vertically
and horizontally accurate in
relation to each other and to
the door.
WEDGE THE DOOR FIRMLY
TO PREVENT MOVEMENT
WHILST DRILLING AND
CHISELLING
Step 1
Lightly mark a height line on
the edge and both faces of
the door and on the door jamb,
to indicate the top of the lock
when fitted. Crease the template
(fire) along the dotted lines
and tape it to the door with the
top in line with the height line.
Mark the holes to be drilled.
Mark the centre line of latch
on to the door edge.
Apply the template to the other
side of the door precisely against
the height line and the centre line
of latch mark. Mark the holes to
be drilled again. (See diagram A).
Step 2
Keeping the drill level and
straight, drill a 25mm (1”) hole
in the centre of the door edge
to accept the latch. Put the latch
into the hole and holding it
square to the door edge, draw
around the faceplate. Remove
the latch. Starting with the top
and bottom cuts, chisel a rebate
to allow the latch faceplate to fit
flush with the door edge.
Step 3
Keeping the drill level and
straight, drill the holes in the
door face. Drill from both sides
of the door to increase accuracy
and to avoid damage to the
other side when a drill goes
right through.
Take time to be precise and finish the job quicker
Step 7
Fit the latch support post to hole
adjacent to
A for a left hand
door, and adjacent to B for a
right hand door.
Diagram A Diagram B