Codelocks CL100 Surface Deadbolt - Manual (Page 2)

Use surface keeper
for inswinging
doors
Use
mortice
keeper for
outswinging doors
RIGHT HAND LEFT HAND
Your door is right-handed if, viewed from outside, the hinges
are on the right.
1. Front plate –
key override option shown
2. Back plate –
bolt is packed separately
3. Neoprene seals x2
4. Packing pieces x2
(for back plate only)
5. Spring loaded spindle
6. Mortice keeper
7. Surface keeper
8. Surface keeper
packing pieces x1
9. Wood screws x2
(to use with keeper)
10. Tweezers
11. Fixing bolts
3 supplied (spare x1)
12. Tumblers (spare x2)
13. Code card
14. 2 keys –
key override options only
Tools required for installation
Power drill
8mm & 13mm drill bits
Bradawl
Philips screw driver size 2
Chisel (maximum 15mm)
Hammer/Mallet
Stanley knife
Pencil
Tape measure
Before commencing installation check that all parts are
working correctly. Press the code according to the code card
and the knob should then turn, in either direction, once only,
and return easily under spring pressure. From inside the door
the bolt can be freely locked and unlocked using the knob.
From outside the code is required both to lock and to unlock
the bolt. If you would like to be able to
LOCK your door from
outside WITHOUT using the code then follow instruction 2.
If you intend to change the code then, if it is convenient, you
should do it before installing the lock. See the code change
instructions in the separate leaflet.
Note that the lock is supplied as standard with a bolt which
projects 40mm from the side of the lock. A shorter bolt
which projects 20mm is available.
1
5 9 13
14
10
11
12
6 7 8
2 3 4
Leave this pin
for right handed doors
Leave this pin
for left handed doors
To enable LOCKING of the
bolt from outside WITHOUT
using the code:
Press the C button to reset the
chamber and place the lock
case on a flat surface with the
buttons down.
Remove the code chamber
plate held in place with the two
red screws.
With the tweezers remove the
right-hand pin for right-handed
doors, or the left-hand pin for
left-handed doors.
Replace the cover plate.
The outside knob will now feel
loose and turn freely in one
direction, and will require the
code to be used before it will
turn in the other direction.
NB When installing the lock
make sure that the driver is in the
correct position before installing
the spindle.
SPECIAL NOTES Surface Deadbolt CONTENTS 2. OUTSIDE KNOB LOCKING ACTION
1. CHECK THE HAND OF YOUR DOOR