CNB MXC6050VR User Manual
Page 16
M
M
V
V
C
C
4
4
0
0
5
5
0
0
V
V
R
R
U
U
s
s
e
e
r
r
’
’
s
s
G
G
u
u
i
i
d
d
e
e
Rev.1.0 (Dec. 2013)
16
4.2. Quick Installation Guide
1. Connect PC and MVC4050VR to network.
1) Prepare a PC to run programs for the installation and video connection
(PC is needed to assign IP address to MVC4050VR)
2) In the case of using PoE, connect the PC and MVC4050VR to the network using one of the following
ways.
If your LAN Switch does not support standard PoE, connect MVC4050VR as shown in dotted line in
Figure 4-1. The DC power is applied through DC adaptor.
Figure 4-1. Power and network connection
2. Install “IP installer and set IP parameters on MVC4050VR
Insert the CD provided with product into the PC. Install WinPcap and IP Installer in sequence. Make sure
that IP Installer can’t run without WinPcap.
IP installer Ver. 3.0.1 or later is needed in the configuration of MVC4050VR.
Follow the sequence below for setting the IP parameter
1) Run IP installer > Select Network Adaptor >OK
2) Click
in IP installer window.> Double click on
①
> Fill in
> make a selection in
> Fill the
②
④
⑤
parameters in ⑥
3) Click on
to apply the settings.
⑨
4) You can connect to admin page by clicking on
.
⑩
LAN switch with
standard POE
(802.3af)
LAN switch
DC adaptor