CNB NVE5055MF User Manual
Page 7
XNET Network Vandal Dome Camera Installation Manual
7 / 21
2
2
.
.
3
3
.
.
2
2
C
C
o
o
n
n
n
n
e
e
c
c
t
t
i
i
n
n
g
g
C
C
a
a
b
b
l
l
e
e
s
s
LINE COLOR
FUNCTION
1
BROWN
Alarm-Out(+)
2
ORANGE
Alarm-Out(-)
3
BLUE
Alarm-In(+)
4
GREEN
Alarm-In(-)
5
RED
MIC/Line-in
6
WHITE
Line-Out
7
BLACK
GND
8
GRAY
Not Used
9
YELLOW
Not Used
Power Input(#1, #2)
Use the cable adapter(DC12V JACK) in the package to connect power.
Please use the accessory power supply provided in the package.
Except when connected to AC24V DC jack please use(DC12V 2A)
Analog Video Output
Use this output for immediate monitoring of the video during installation.
Use the supplied cable adapter
(Yellow for video and White for Video Ground GND)
This adapter can be connected to a cable through a BNC terminal Output connector.
(Select Video Out at menu screen to enable this output)
Audio Connection
MIC/Line Input (Mono)
Connects to auxiliary Audio device or microphone.
Line Output (Mono)
Audio signal output to a Power Amplified device or Speaker. This can be used to listen to the audio
signal sent from a remote PC for Bi-directional Audio communication.
Alarm Connection
These wires connect to Alarm input/output devices.
Alarm Sensor Input: Connect to Alarm sensor devices such as IR Sensor or Heat sensor. These can
be configured to
normally close or normally open operation. (#1, #2)
Alarm Output: Connect to Alarm devices such as Relay operated
Siren Lamp or Alarm Light.
These can be configured to
normally close or normally open operation. (#3, #4)
Please refer to “2.3.3 Connection to Alarm Devices” for detailed instruction on how to connect
sensors and Relays.
Do not use the other power connector when powering up the product through PoE.
The Product is not covered under warranty when it is damaged by connecting both
Ethernet power and 12V DC power (or 24V AC power) to this terminal.