CNB IGC2050F User Manual
Page 7
7 / 17
XNET Network Box Camera Installation Manual
2
2
.
.
3
3
.
.
2
2
.
.
F
F
r
r
o
o
n
n
t
t
/
/
R
R
e
e
a
a
r
r
V
V
i
i
e
e
w
w
Figure 2-2. Network Camera Front / Rear view
z
STATUS LED : Indicate the status of the product
EVENT LED : If the alarm out is operating, the green LED blinks.
SYSTEM LED : The system operates normally when the blue LED blinks
z
MIC : Have built-in microphone.
z
LINE IN: Connects to auxiliary Audio Device. 3.5 mm mono/ stereo audio
connector is used. For connection, refer to the figure below:
Figure 2-3. Connector for LINE INPUT and Audio LINE OUT
z
LINE OUT: Audio signal output to a Power Amplified device or Speaker. This can be used to listen to
the audio signal sent from a remote PC for Bi-directional Audio communication.
z
VIDEO OUT: Use this output to monitor the analog video signal while installing.
(Select Video Out at menu screen to enable this output)
z
Factory Reset : Press and hold for more than 3 seconds while power is on to recall factory default
settings
LINE IN(mono)
/MIC IN
GROUND
GROUND
LINE
OUT(mono)
MIC
STATUS LED
Factory
Reset
Power LED