beautypg.com

To use the heated dryer rack, Open dryer door, A. front edge – Amana W10216186A User Manual

Page 23: A. dryer rack front edge, B. dryer back panel, Close the door, Start the dryer, Dryer rack, Cycle, Temp

background image

23

To use the heated dryer rack:

Do not remove the lint screen.

1. Open dryer door.

A

A. Front edge

2. Place dryer rack over the bottom of the dryer door opening.

Rest the back wire on the dryer back ledge. Push down on
the frame front to secure over lint screen.

A

B

A. Dryer rack front edge
B. Dryer back panel

3. Place wet items on top of the rack. Allow space around items

for air to circulate. The rack does not move, but the drum will
rotate. Make sure items do not hang over the edges or
between rack grille.

4. Close the door.

5. Rotate the dial to the Air Fluff cycle or press Timed Dry.

Select a drying time by pressing MORE TIME or LESS TIME.
Press TEMPERATURE until the desired temperature glows.
Items containing foam, rubber, or plastic must be dried on a
clothesline or by using the Air Fluff cycle. Refer to the
following table.

6. When Air Fluff is selected, the Estimated Time Remaining

display shows the default time. You can change the actual
time in the cycle by pressing More Time or Less Time.

7. Start the dryer.

NOTE: Check the lint screen and remove any lint accumulated
from items dried on the rack after the cycle is finished.

Dryer Rack

Cycle

Temp.

Time*

Wool sweaters

Block to shape and lay flat
on the rack

Timed Dry

Low

60

Stuffed toys or pillows

Cotton or polyester fiber
filled

Timed Dry

Low

60

Stuffed toys or pillows

Foam rubber filled

Air Fluff

Air Only

(no heat)

90

Sneakers or canvas
shoes

Air Fluff

Air Only

(no heat)

90

*Reset cycle to complete drying if needed.

NOTE: You must remove rack for normal tumbling. To remove the
dryer rack, lift it straight up and out of the dryer.

DRYER CARE

Cleaning the Dryer Location

Keep dryer area clear and free from items that would obstruct the
flow of combustion and ventilation air.

Cleaning the Lint Screen

Every load cleaning

The lint screen is located in the door opening of the dryer. The
control panel has an indicator light to remind you to clean the lint
screen before each load. A screen blocked by lint can increase
drying time.

To clean

1. Pull the lint screen straight up. Roll lint off the screen with

your fingers. Do not rinse or wash screen to remove lint.

Wet lint is hard to remove.

2. Push the lint screen firmly back into place.