Clock Audio Non wireless bases - Manual (Page 2)

Latching / Normally on (Press touch switch to mute the microphone)
This option will allow the microphone to be always live when powered up. Press
touch switch to mute the microphone.
Note:
It’s important to ensure that any touch switch input operations are made within
2 seconds after seeing either slow or rapid flashing of the led indicator. Failure to do
so will prevent the correct programming taking place. Simply switch the power off for
5 seconds and start again.
Setting Programme mode
Press and hold down the touch switch and at same time slide the power
switch to its on position then immediately release the touch switch. The
red led will rapidly flash. If it does not then switch power off and wait a few
seconds then try again. Do not proceed until you see rapid flashing of the
led.
Changing the Programme
After the red led stops rapidly flashing press the touch switch once and wait
for the led to flash then press the touch switch twice wait for the led to flash
followed by rapid flashing. Press touch switch twice wait for flash, press touch
switch twice wait for flash followed by rapid flashing after the flashing stops
wait a further 15 seconds to allow the new data to be programmed into the
processor. The wireless base has now been set to Latching normally on and
can now be used.
Easy programme steps

Set programme mode as detailed above (identified by rapid flashing)

Press once and wait for flash.

Press twice wait for rapid flashing

Press twice wait for flash

Press twice wait for rapid flashing and wait 15 seconds before using.