American Dryer Corp. ML-78 - Manual (Page 24)

20
2. Electrical Service Specifications
IMPORTANT: The dryer must be connected to the electric supply shown on the data label that is
affixed to the back of the dryer, at the upper right hand corner. In the case of
208 VAC or 240 VAC, the supply voltage must match the electric service
specifications of the data label exactly.
IMPORTANT: The wire size must be properly sized to handle the related current.
WARNING: 208 VAC and 240 VAC ARE NOT THE SAME. Any damage done to dryer
components due to improper voltage connections will automatically VOID THE
WARRANTY.
NOTE: For electrically heated models, contact the factory for electrical service specifications.
NOTE: ADC reserves the right to make changes in specifications at any time, without notice or
obligation.
MLG-78 (Gas)
MLS-78 (Steam)
E
LECTRIC
S
ERVICE
S
PECIFICATIONS
(
PER DRYER
)
IMPORTANT: 208 VAC and 240 VAC ARE NOT THE SAME. When ordering, specify exact voltage.
NOTE: A. Fuse ratings are dual-element, time-delay, current limiting, class RK1 or RK5 ONLY.
B. Circuit breakers are thermal magnetic (industrial) type ONLY. For others, calculate/verify correct breaker
size according to appliance amp draw rating and type of breaker used.
C. Circuit breakers for 3-phase dryers must be 3-pole type.
SERVICE
VOLTAGE
PHASE
WIRE
SERVICE
APPROX.
AMP
DRAW
MINIMUM
WIRE SIZE
FUSING
CIRCUIT
BREAKER
Dual Element
Time Delay
120 60 Hz 1ø 2 13 #10 20 25
208 60 Hz 1ø 2 8 #14 12 15
208 60 Hz 3ø 3 5 #14 8 15
240 50/60 Hz 1ø 2 7 #14 10 15
240 50/60 Hz 3ø 3 5 #14 8 15
380-400 50 Hz 3ø 3 3 #14 5 15
416 50 Hz 3ø 3 3 #14 5 15
460 60 Hz 3ш 3 3 #14 5 15