King Technology Sparco System - Manual (Page 9)

Corrosion
Resistant Check
Valve
Above Ground Filter Installation
Brush sealant on one
threaded end of nipple.
Screw nipple into the filter
return.
Brush sealant on threads of one
(either) bushing and open
threads of nipple. Screw Sparco
Cycler on to nipple counter
clockwise until upright and
secure.
Tighten turning
1 to 2 revolutions with wrench.
DO NOT OVER TIGHTEN.
PIPE
THREAD
PIPE
THREAD
PIPE
THREAD
PIPE
THREAD
PIPE
THREAD
HOSE
ADAPTER
HOSE
ADAPTER
THREADED
REDUCER
BUSHING
THREADED
REDUCER
BUSHING
HOSE ADAPTER
Attach return section of hose
to the adapter with clamp and
tighten with screwdriver.
TOOLS NEEDED
Screwdriver
Installing a corrosion resistant
check valve is recommended.
Pipe
Thread
Sealant
One Hose Adapter
1 1/2"
X 1 1/2" X 1 1/4"
One 6" X 1 1/2" TBE
PVC Nipple
One Section of
1 1/2" Flex Hose
(provided with filter)
Pipe Wrench
Two 2” threaded by
1-1/2” threaded
bushings
Following pipe thread sealant
directions, brush sealant on filter
threads.
Screw a bushing
into each port of
Sparco Cycler and hand
tighten.
Completely tighten turning 1
to 2 revolutions with wrench.
DO NOT OVER TIGHTEN.
DO NOT USE TAPE
as the
threads on
these units
are not suitable
for this use and leaking
or bushing failure could
result.
Brush sealant on female
threads of other bushing and
threaded end of hose adapter.
9
MATERIALS NEEDED:
One
Hose Clamp
RECOMMENDED:
4. 5.
8.
1. 3.
9.
2.
Water
CYCLER
Metered
Pool Purifier 6.
7.
Water
CYCLER
Metered
Pool Purifier
AUTOMATIC WATER TREATMENT SYSTEM
AUTOMATIC WATER TREATMENT SYSTEM
AUTOMATIC WATER TREATMENT SYSTEM
Screw adapter into bushing
on the open end of the
Sparco Cycler.
Completely tighten turning
1 to 2 revolutions with
wrench. DO NOT OVER
TIGHTEN.
AUTOMATIC WATER TREATMENT SYSTEM
Brush sealant on threads of
both Sparco Cycler ports
and male threads of both
bushings. DO NOT USE
TAPE.