Aluratek AIREC01F - Manual (Page 7)

8
Chapter 3: Configuration
Go to next
screen
Notes
1. POWER ON
Scanning for
available APs.
Device is running
as a Wireless
Client.
Screenshot Instructions
2.
3.
There are three modes of network configuration for AIREC01F. It can be a
wireless client, a wired client, or even a wireless access point (Wireless AP).
3.1 Configure as an Wireless Client
The factory default mode is the wireless client code. According to the
availability of an Ethernet cable, the device will automatically select a
suitable client mode to operate. User can also manually change the set-
ting of network configuration through the Setup menu “Setup/Advanced
Setup/Configure Network”.
AIREC01F will connect wirelessly if it detects an 802.11b/g wireless
network. With no Ethernet cable attached, you just need to power on the
device and AIREC01F will automatically enter the wireless client mode.
To connect AIREC01F to the wireless network for the first time, you will
need to set the encryption key for a secured network. Once the setting is
finished, the device will remember the related settings and try to connect
to the designated AP when it is power on next time. However, if there
is something trouble in connecting to the designated AP, the device will
show the AP list screen for you to configure again
First time using device without an Ethernet cable plugged in: