INTELLINET NETWORK ICC-130 Hardware Installation Guide - Manual (Page 4)

Factory Reset
Reset: With the camera turned on, press the reset button briefly to
reboot the camera, or hold the reset button for 10 seconds to set all
settings back to factory default values.
Hardware Installation
1. Use the two supplied screws to fix the base plate to a flat surface.
2. Loosen the screws on the bracket in order to adjust the camera’s
viewing area.
3. Tighten the screws at the two joints of the bracket to fix the camera
in place.
4. Above: It is recommended to install the network camera in an area where the
camera is not directly exposed to sun light, rain or snow. For example, install the
camera underneath an overhang, such as a roof, to increase the camera’s life
span.