Hach-Lange E300 Electrode stand - Manual

1
DOC302.53.00787
Instruction Sheet
Electrode stand E300
Safety Information
Please read this entire document before unpacking, setting up, or operating this equipment.
Failure to do so could damage to the equipment.
To ensure that the protection provided by this equipment is not impaired, do not use or install
this equipment in any manner other than that specified in this document.
Installation
The electrode stand E300 is delivered in two parts. Before use, assemble the steel base with
its blue plastic cover and the arm part as follows.
1. Remove the circlip ( Figure 2 on page 2 , item 2 ) seated in the groove ( Figure 2 on page 2 ,
item 4 ) at the lower end of the pivot.
2. Insert the pivot ( Figure 2 on page 2 , item 1 ) in the base ( Figure 2 on page 2 , item 3 ) and
turn the E300 upside down ( Figure 2 on page 2 , item 5 ) so that the metal part of the base
is uppermost.
Figure 1 Electrode stand E300
1 Holder head 4 Base
2 Friction screw 5 Springs
3 Arm