Hydrotech 6700 XTR Downflow Valve Water Softener - Manual (Page 4)

2
LED Status Lights:
Blue LED: Illuminates while the unit is in service and no errors exist. The unit will always be in service unless a
regeneration trigger has occurred (green LED light will be displayed).
Green LED: Illuminates when the unit is in Regeneration mode, unless an error condition exists.
Red LED: Illuminates when there is an error.
Timer Operation During A Power Failure
All program settings are stored in permanent memory. Current valve position, cycle step time elapsed, and time of day are
stored during a power failure, and will be restored upon power re-application. Time is kept during a power failure, and time
of day is adjusted upon power up (as long as power is restored within 12 hours).
NOTE: The time of day on the main display screen will flash for 5 minutes when there has been a power outage. The
flashing of the time of day can be stopped by pressing any button on the display.
Set Feed Water Hardness
1. Press the Shift, Up, and Down buttons to move the cursor and change the value of the numbers.
2. Press the Extra Cycle button to proceed to the next step.
NOTE: Only displayed when a metered option is chosen under System Type.
Model 6700XTR Programming Chart - Customer Use
To enter USER PROGRAMMING MODE, press
and hold the Up and Down buttons for 5 seconds.
NOTE: Depending on current option settings,
some displays cannot be viewed or set.