AVerMedia Technologies LX5000 - Manual (Page 10)

AVerMedia LX5000 User’s Manual
19
Chapter 4 System Configuration and
Operation
4.1 Entering the System
Before you start running LX5000 system, the system will perform a
routine hardware check-up and scan all hard disks. In general, the hard
disk scan takes only a few seconds. But if the hard disk was abnormally
shutdown or had been damaged, the system will do a complete scan.
The scan time is dependent on the hard disk size. (with a complete scan,
it takes about 1 minute to scan 30GB).
If you re-installed your LX5000 system and forgot your
previous password, you can choose to remove the previous
password setting when the first time you enter the system after the re-
installation.
After the hardware check-up is finished, a dialogue box will display
prompting you to set some basic configurations. You only have 15
seconds to finish all the selections on this screen.
Remove password setting (y/n)?
AVerMedia LX5000 User’s Manual
20
For Select Language, you can select from
English, Traditional Chinese, Simplified
Chinese, Japanese, German, French, Polish,
and Czech.
After your selection, a pop-up window
besides will allow you to utilize the system
application.
Enter user serial number in Serial Number field to further use
AVerMedia LX5000