Autostart AS-1452 HF - Manual (Page 4)

P. 4 User Guide
also unlock the doors.) In Passive Mode, the system will automatically rearm 1 or 3
minutes after the doors were unlocked.
• To arm the Starter Kill in Active or Passive Mode, press and hold the
LOCK
button on the
transmitter. The parking lights will flash once. (If Remote Door Locks were installed, this
will also lock the doors). In Passive Mode, the system will automatically arm 1 or 3 minutes
after the engine is shut down.
Remote-starting Your Vehicle
If your vehicle has an automatic transmission, simply press the START button to remote start
or stop your vehicle. Skip the next steps on to “Remote-starting”.
Warning: If you vehicle has an automatic transmission and the parking lights flash 15 times
after pressing the START button, the parking brake is connected to ground. It is imperative
that you see your installer and have him disconnect the wire.
Setting Your Vehicle Into Ready Mode
If your vehicle has a manual transmission you must read the following indications. In order to
start the vehicle by remote, the unit must first be set to Ready Mode. If the unit is not set to
Ready Mode, it cannot remote-start the vehicle.
Once the system is set to Ready Mode, the vehicle can be remote-started and stopped at
wish.
To set the system to Ready Mode:
1. Ensure that all the doors are closed and that the shifter is in the
NEUTRAL position.
2. With the engine already running, apply the parking brake and release the brake
pedal.
• Make sure to release the brake pedal.
3. Within 20 sec. press
LOCK
,
UNLOCK
or
START
on the transmitter.
• The parking lights will flash 3 times quickly and remain lit.
4. Remove the key: the engine will go on running.
5. Exit the vehicle and close the door.
6. Press and hold either:
1.
LOCK
to lock the doors and shut down the engine;
2.
UNLOCK
to unlock the doors and shut down the engine;
3.
STOP
to shut down the engine without affecting the doors.
Remaining In Ready Mode
Once the vehicle is in Ready Mode you can start and stop the vehicle at wish. However,
should any of the following occur, the vehicle will exit Ready Mode – thus eliminating the
remote start option until Ready Mode is restored:
• Door opened;
• Hood opened;
• Brake pedal pressed;
• Parking brake disengaged;
• Ignition key turned to the
IGNITION ON (RUN)
position.
Note: The unit will notify the user that it has exited Ready Mode by giving 3 slow flashes
(parking lights).
Remote-starting
Press the
START
button for approx. 1 second. The parking lights will come
ON
to inform you
that the Remote Car Starter has received your signal. Approximately 5 seconds later, the
engine will start. The parking lights will remain
ON
during the pre-programmed run time of the
engine.