Alliance Laundry Systems SFGX09*F - Manual (Page 40)

© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT 38 510977
Maintenance
Lubrication
All moving parts are sealed in a permanent supply of
lubricant or are equipped with oilless bearings.
Additional lubrication will not be necessary.
Care of Your Dryer
Dryer Interior
Wipe the surfaces using a soft cloth and household
cleaner or a non-abrasive paste of powdered laundry
detergent and hot water, followed by a short heat cycle
with a load of rags.
To remove crayon or ball point ink off the dryer drum,
put the heat on high and use old rags in the dryer to
absorb the crayon or ink. If unsuccessful, contact the
appliance dealer. DO NOT use any chemicals in the
dryer.
IMPORTANT: The use of chlorine bleach for
removing any discolorations should be avoided
because bleach could damage the finish.
Cabinet
Wipe the dryer cabinet as needed. If detergent, bleach
or other washing products have been spilled on the
dryer, wipe immediately. Some products will cause
permanent damage if spilled on the cabinet.
Control Panel
Use only a damp or sudsy cloth for cleaning the
control panel. Some spray pretreat products may harm
the finish on the control panel.
NOTE: The wiring diagram is located inside the
control panel.
Exhaust System
The exhaust duct should be inspected after one year of
use and cleaned if necessary by a qualified service
person to remove any lint build-up. Inspect and clean
exhaust duct every one to two years as required
thereafter.
The weather hood should be checked frequently to
make sure the dampers move freely, dampers are not
pushed in and that nothing has been set against them.
Keep dryer area clear and free from combustible
materials, gasoline and other flammable vapors and
liquids.
Do not obstruct the flow of combustion and ventilation
air.
NOTE: Verify proper operation after servicing.
Lint Filter
CLEAN THE LINT FILTER BEFORE DRYING
EACH LOAD. (Refer to Figure 61 for lint filter
location.) Cleaning the lint filter is important because
a layer or pad of lint on the filter will block the flow of
air through the dryer, thus reducing the efficiency of
the dryer. The clothes will take longer to dry and
energy will be wasted.
The lint filter may be washed if needed. Annually
remove lint filter and screw to vacuum the duct under
it.
Figure 61
To reduce the risk of an electric shock,
serious injury or death, disconnect the
electrical service to the dryer before
cleaning the interior.
W132
WARNING
Label all wires prior to disconnection
when servicing controls. Wiring errors
can cause improper and dangerous
operation.
W049
WARNING
D625I
1 Lint Filter
To reduce the risk of electric shock,
disconnect the electrical service to the
dryer before cleaning.
W043
WARNING
IN U SE
PE RM P RE SS
NO RM AL FL UF F (N O H EA T) DE LIC AT E
PU SH TO S TA RT
FA BR IC S EL EC TO R
50 42 10
OP ER ATIN G IN STR UC TIO NS
CLEAN LINT FILTER A
FT ER EACH LOAD
1. 2. 3. 4. 5. 6.
Se lec t F abr ic T ype (h eat set ting )
N OR MA L, P ER M P RE SS ,
D EL ICA TE , F LU FF (n o h eat )
Loa d C loth es. Ins ert Co in(s )/C ard .
To St art Dr yer - C los e D oor an d P ush St art .
To St op Dry er Du ring Cy cle - O pen Do or.
To Re sta rt D rye r - Clo se Do or a nd Pu sh Sta rt.
Dry ing Cy cle is Co mp lete W hen Pa nel L igh t G oes Off .
D625I
1