GeneralAire TERsus 2000 User Manual
Page 7
6
5.
Tape all seams between the air handler and the outlet side of the GeneralAire TERSus 1200/2000 so that there
can be no air bypassing the system.
6.
Attach the air handler to the outlet side of the GeneralAire TERSus 1200/2000 and fasten with #10 x 3/8 self-
drilling sheet metal screws. Note: only 1/2 inch of clearance has been provided between the outer and inner case.
7.
Slide the inner module into the outer encasement and tighten locking knobs finger tight. Make sure the inner
module will freely slide in and out of the outside enclosure.
8.
Plug in the power cord to any 120vac outlet and check both sight ports to make sure both lamps are
illuminated. Ultraviolet lamps must remain on at all times regardless of thermostat or AirCycler settings.
9.
Check the service panel. The LED lights should be flashing in sequence for a 15 second period of time and then
return to green. The filter lamp should be flashing green and the UV lamp light should be a steady green.
10.
Set the thermostat or the AirCycler to operate the fan unit for at least 30 minutes every hour. If air quality
problems persist after one week, increase the fan unit operating time by (5) minute intervals.
fIg. 9
fIg. 8