GeneralAire DS50 LC Elite Steam - Manual (Page 9)

DS 50 / DS 50 LC +030222065 Rev. 1.2 9
F
3. INSTALLATION
3.1 Positioning
The Elite Steam has been designed for wall mounting and, since it is an atmospheric steam
humidifier, should be placed close to the point where the steam will be used, to minimize the
steam hose length (and the amount of condensate). Do not mount on furnace, air handler or
ductwork. Certain clearances must be maintained around the unit for safety and
maintenance.
3.2 Mounting
3.2.1
Removing the front cover
The front cover is secured by two screws located in the bottom side of the unit. Use a phillips
screwdriver to remove the screws. The front is clasped with 2 clips on the top of the back
part. To remove the front cover, hold by the sides pivot the bottom out and lift cover. When
installing the cover, be careful not to over-tighten the screws.
screws M5x16
Fig. 3.c
Fig. 3.d
Millimeters Inch
A (150 mm) 6”
B (150 mm) 6”
C (150mm) 6”
D (150 mm) 6”
E (600 mm) 24”
F max. 0.2°
Tab. 3.a
Fig. 3.a
Clearance Dimensions
Millimeters Inch
A 445 mm 17.5“
B 290 mm 12“
C 790 mm 32“
Kilograms Pounds
Weight empty 11kg 24 lbs
Weight packaged 13kg 29 lbs
Weight installed with water 23kg 51 lbs
Tab. 3.c
Unit Dimensions: Duct Units
Fig. 3.b SCREWS M5x16