BJM Pumps KZN-HYD6R - Manual (Page 27)

28
Insert shaft key (#42) into shaft.
Slide impeller t#40t onto snarl.
Install wear plate (#44) onto suction cover (#43) with (4) bolts (#46) with nuts and Iock-
washers.
Install suction cover assembly. onto volute (#32) and secure with (4) bolts (#45).
Place lock-washer (#51) over shaft and install (screw on) agitator (#52).
Using pry bar or other suitable tool, secure impeller while tightening agitator with pipe
wrench or similar tool.
Install strainer base (#48) with (4) 12mm x 25mm bolts (#47) with lock-washers.
Install O ring (# 49) onto bearing support assembly.
Install outer casing (#14) onto bearing support and install and tighten (8) bolts (#28)
with Iock-washers.
Install hydraulic motor (#16) onto motor support plate (#18) and fasten with (4) bolts
(#17) with lock-washers.
Install wave washer (#19) and O ring (#20) into motor support plate (#18) using grease
to keep wave washer in place.
Apply grease to splined shaft on hydraulic motor (#16) and carefully install motor and
support plate assembly. into top of outer casing (#14) and over bearing (#21).
Install O rings (#5) onto threaded ends of oil pipes (#3) and install oil pipes into top of
hydraulic motor (#16).
Install O rings (#4) into oil pipe grooves.
Slide the spacer ring (#15) into the outer casing (#14).
Install O ring (#11) onto top cover (#10) lightly lubricate O rings (#5) and slide cover
over oil pipes. Align top cover bolt-holes with outer casing threaded bolt-holes and
install (6) 10mm x 35mm bolts (#9) with lock-washers.
Install discharge adapter (#12) with (4) 12mm x 35mm bolts (#13).
Install lifting bracket (1) with (2) bolts (#2).