Biamp TDT300 - Manual (Page 3)

TDT100 & TDT300 INSTALLATION INSTRUCTIONS
FIGURE 10
1. Disconnect AC power from the amplifier.
2. Remove the amplifier top panel by removing 17 screws
(6 on each side, 3 on back and 2 on front).
Please note that front screws are longer.
3. If the mounting bolts have two nuts, remove one and
save. These nuts will be used to hold the transformers
in place. If the mounting bolts have only one nut, do
not remove. Transformer will be held in place with
supplied nut.
4. Install transformers as shown in figure 6.
5. Locate the amplifier circuit boards and jumpers.
Each amplifier card represents two individual output
channels; one odd and one even (refer to figure 7 for
reference).
6. Using a pair of pliers, remove the red jumper from
both amplifier channels.
7. Following the diagram below (figure 8), connect the
wires as indicated.
8. Replace amplifier top panel (longer screws go on the
front).
9. Assign channel HPF (High Pass Filter) by flipping the
appropriate channel rear panel dip switch. (figure 9)
10. Assign bridge mode by flipping the rear panel bridge dip
switch (figure 9)
11. Apply appropriate rear panel “xfmr” voltage sticker.
(figure 10)
Odd channel
jumpers (Ch 1)
Even channel
jumpers (Ch2)
Amplifier
Cards
Nut
Metal Dome Washer
Rubber Washer
Transformer
Rubber Washer
Bolt
Even
Channels
(2, 4, 6, & 8)
Odd
Channels
(1, 3, 5, & 7)
Black wire Brown wire = 25V
Orange wire = 70V
Yellow wire = 100V
Blue wire Green wire
Affix transformer
stickers
High Pass Filter
(HPF)
dip switches
FIGURE 6
FIGURE 7
FIGURE 9
FIGURE 8
Bridge
dip switch