Flowline AVX6 Float-Point - Manual (Page 10)

10 of 14 Switch-Tek Float Series 22 AUG 08
MN801839 Rev A
Electrical Interface
Typical Current and Voltage Ratings
Watts Voltage Current Amps
15 240 AC
120 AC
100 DC
24 DC
-
0.12
0.10
0.30
30 240 AC
120 AC
100 DC
24 DC
0.14
0.28
0.07
0.28
60 240 AC
120 AC
100 DC
24 DC
0.40
0.50
0.20
0.50
100 240 AC
120 AC
100 DC
24 DC
0.40
1.00
0.40
1.00
• Note: The ratings at right are for resistive loads only. For inductive loads, maximum
switch life will be achieved if appropriate arc suppression is used.
• The following part numbers; LV36-S201, LV36-S401, LV35-S201, LV35-S401,
LV20-2101, LV20-2201, LV21-1101, LV21-1201, LH35-S201, LH25-1201, LH25-
1401 and LH29-1001, are all two wire reed switch outputs where polarity does not
matter.
• Part numbers LV36-S501 and LV20-1501 are reed switch outputs with two additional
wires that are used to output the 100-ohm RTD used to measure the temperature of
the environment.