Flowline DL10 EchoPod - Manual (Page 2)

We do Your Level Best We do Your Level Best
We Do Your Level Best
Thank you for purchasing the EchoPod ® (DL10). This general purpose ultrasonic
sensor provides non-contact detection powered by the 4-20 mA loop. This Quick Start
includes everything you’ll need to get the EchoPod
® up and running. For complete
information, please refer to EchoPod ® documentation located at www.flowline.com .
Components
Depending on how the EchoPod ® was shipped to you, you may or may not have the
components shown below. All three components, including the EchoPod ® , USB Fob,
and Viton ® gasket are required to configure and install the EchoPod ® . If you need any
additional components, you can order them directly from your local Flowline
distributor.
General notes for electrical connections, usage and safety:
 Where personal safety or significant property damage can occur due to a
spill, the installation must have a redundant backup safety system installed
 Wiring should always be completed by a licensed electrician
 Supply voltage should never exceed 28 VDC
 Protect the sensor from excessive electrical spikes by isolating the power
whenever possible
 The sensor materials must be chemically compatible with the liquids to be
measured
 Design a fail-safe system for possible sensor and/or power failure
 Never use the sensor in environments classified as Hazardous
Welcome to the DL10 Quick Start
The DL10 Quick Start is meant to show some of the more common setup
solutions to getting the DL10 up and running quickly. If you run into an issue that
is not addressed here or wish to install or set up with a non-standard
configuration, please address the DL10 Manual or refer to the Flowline website
at
www.flowline.com .
EchoPod ®
DL10-0
DL10-1
USB Fob
LI99-1001 Viton ® gasket
204038
Typical Wiring Diagram
Your WebCal Wiring Diagram may vary.