Fill-Rite SD62 Rotary Pump - Manual (Page 2)

2
SD62G8529 REV. 2
ITM. PART
NO. NO. DESCRIPTION QTY.
SD62 PUMP PARTS LIST
TROUBLESHOOTING GUIDE
PRODUCT WARRANTY
Tuthill Transfer Systems (“Manufacturer”) warrants to each consumer buyer of its Fill-Rite products (the
“Buyer”), from the date of invoice or sales receipt, that goods of its manufacture (“Goods”) will be free from
defects of material and workmanship. Duration of this warranty is as follows:
- Heavy Duty Products - Two years
- Standard Duty Products – One year
- Economy Duty Products – One year
- Cabinet pumps, Parts, and Accessories -One year
Manufacturer’s sole obligation under the foregoing warranties will be limited to either, at Manufacturers’
option, replacing or repairing defective Goods (subject to limitations hereinafter provided) or refunding
the purchase price for such Goods theretofore paid by the Buyer, and Buyer’s exclusive remedy for breach
of any such warranties will be enforcement of such obligations of Manufacturer. If Manufacturer so
requests the return of the Goods, the Goods will be redelivered to Manufacturer in accordance with
Manufacturer’s instructions F.O.B. Factory. The remedies contained herein shall constitute the sole
recourse of the Buyer against Manufacturer for breach of warranty. IN NO EVENT SHALL
MANUFACTURER’S LIABILITY ON ANY CLAIM FOR DAMAGES ARISING OUT OF THE MANU-
FACTURE SALE, DELIVERY OR USE OF THE GOODS EXCEED THE PURCHASE PRICE OF
THE GOODS. The foregoing warranties will not extend to Goods subjected to misuse, neglect, accident
or improper installation or maintenance, or which have been altered or repaired by anyone other than
Manufacturer or its authorized representative. THE FOREGOING WARRANTIES ARE EXCLUSIVE
AND IN LIEU OF ALL OTHER WARRANTIES OF MERCHANTABILITY, FITNESS FOR PURPOSE
OF ANY OTHER TYPE, WHETHER EXPRESS OR IMPLIED. No person may vary the foregoing
warranties and remedies except in writing signed by a duly authorized officer of Manufacturer. Warranties
or remedies that differ from the foregoing shall not otherwise be binding on Manufacturer. The Buyer’s
acceptance of delivery of the Goods constitutes acceptance of the foregoing warranties and remedies, and
all conditions and limitations thereof.
1 SD62G8547 Pump Body 1
POSSIBLE CAUSE SOLUTION
Pump will not prime
1. Suction line problem Check for leaks in suction line
2. Vanes sticking Check vanes and slots for nicks, burrs or wear
3. Gasket leakage Tighten covers and joints
4. Excessive rotor or vane wear Check rotor and vanes for excessive wear or damage
Low pump capacity
1. Suction line problem Check for leaks in suction line
2. Excessive rotor or vane wear Check rotor and vanes for excessive wear or damage
Pump fluid leakage
1. Dirty Seal Clean O-ring seal and seat area
2. Bad seal Replace seal
3. Gasket leakage Tighten covers and joints