AT&T 7630 - Manual (Page 30)

2 9
Replacing the Handset Battery Pack
1 Remove the battery compartment cover on the handset by pressing on
the indentation and sliding the cover downward.
2 Lift out the old battery pack and unplug it from the handset.
3 Hold the new battery pack and plug the cord into the handset. Place
the battery pack and wires in the compartment, as shown below.
4 Replace the cover by sliding it on its track up over the battery compart-
ment until it snaps firmly in place.
5 The new batteries must be charged before using this telephone. Place
the handset in the base unit and allow it to charge for 4 hours. The
telephone may operate before that, but for best performance, let the
batteries charge fully.
HANDSET BATTERIES
7630_book.1AT&T 8/12/98, 6:29 PM 29