AT&T 7630 - Manual (Page 27)

2 6
ANSWERING SYSTEM OPERATION
At Cordless Handset or Touch Tone Phone
Remote ON/OFF
Review ON/OFF Status
Connect with the answering system. Press ). The system announces the current
status, then beeps twice and is ready to accept a command.
Turning System Off
1 Connect with the answering system.
2 Press * 0. The system announces "The machine is off," then beeps
twice to indicate it is ready to accept a command.
Turning System On
When the system is off, it answers after 10 rings, and announces “The machine is
off,” then beeps twice to indicate it is ready to accept a command. Press
* 0. The
system announces "The machine is on," then beeps twice.
Recording a Message When System is Off
Press # when the system answers after 10 rings. The system will beep to signal
you to begin speaking.
Changing Settings
1 Connect with the answering system.
2 Press *, 9. You hear “To listen to settings, press 9.”
3 Press 9. You hear the currently selected announcement, followed by
“To select a different announcement, press 6 or 4.”
4 Press 6 or 4 to change the selected announcement. Press 9 to save
the setting.
5 The system announces the current ring select setting, followed by "To
change the number of rings or select toll saver, press 6 or 4."
6 Press 6 to increase number of rings, or 4 to decrease number of rings.
Press 9 to save the setting.
7 The system announces the current message alert setting, followed by
"To turn on or off, press 6 or 4."
8 Press 6 or 4 to change the setting. Press 9 to save the setting.
9 The system announces Remote Access Code, followed by "To select the
first digit, press 6 or 4, then press 9."
10 Press 6 to increase the first digit or 4 to decrease it, then press 9 to
save it. Continue in the same way for the second and third digits.
7630_book.1AT&T 8/12/98, 6:29 PM 26