EBARA EFQT12 - Manual (Page 4)

EBARA Fluid Handling 3
INTRODUCTION
If there are any questions regarding the pump or its applications which are not covered in this manual or
in other literature accompanying this unit, please contact your EBARA distributor, or write:
EBARA Fluid Handling
1651 Cedar Line Drive
Rock Hill, SC 29730
For information or technical assistance on the power source, contact the power source manufacture’s
local dealer or representative.
The following are used to alert maintenance personnel to procedures which require special attention, to
those which could damage equipment, and to those which could be dangerous to personnel:
This Installation, Operation, and
Maintenance manual is designed to help
you get the best performance and
longest life from your EBARA pump.
This pump is a EFQT Series, semi-open
impeller, self- priming centrifugal model
with a suction check valve. The pump is designed for handling mild
industrial corrosives, mud or slurries
containing large entrained solids. The basic
material of construction is gray iron, with
ductile iron impeller and steel wearing parts.
DANGER!
Immediate hazards which WILL result in
severe personal injury or death. These
instructions describe the procedure required
and the injury which will result from failure
to follow procedure.
CAUTION!
Hazardous or unsafe practices could result in
minor personal injury, product or property
damage. These instructions describe the
requirements and the possible damage which
could result from failure to follow the
procedure.
NOTE
Instructions to aid in installation, operation,
and maintenance or which clarify a procedure.