AT&T 1460 - Manual (Page 45)

4 2
TELEPHONE OPERATION
PROBLEM SOLUTION
If you hear a two-beep • You might be out of range. Move close
signal when you try to
to the base and try again.
use the handset: • If moving closer to the base doesn’t help,
try following the directions above for re-
initializing the handset and base.
PROBLEM SOLUTION
If the phone does not • Make sure the handset ringer is on.
ring when you receive • Make sure the telephone line cord is
a call:
connected firmly to the base and the
telephone jack.
• Make sure the AC adapter is plugged
firmly into an outlet not controlled by a
wall switch.
• You might be too far from the base;move
closer.
• You might have too many extension
phones on your telephone line to allow
all of them to ring. Try unplugging some
of them.
PROBLEM SOLUTION
If the NEW CALL light You may still have unreviewed (new) calls
on the base does not go somewhere in your call history. Make sure
off after you review
you review your entire call history.
your Caller ID
information in the call
log:
91-5387-30-00_ATT1460_R1 2003.3.27 10:21 AM Page 42