Auto Page RS-860 lcd - Manual (Page 24)

24
light will flash (3) times. The siren or horn chirps (3) times. The vehicle is now
programmed to start every (3) hours.
3-b. Daily Timer Start: Depress the transmitter button
first, within 3 seconds press ( ) button. The
parking light will flash (6) times. The siren chirps (6)
times. The vehicle is now programmed to start at the
real time of the next day. Your set time for the next
day engine start flashes for approx. 3 seconds on the
LCD screen. After 3 seconds the icon stays
displayed on the LCD screen.
4. Press the brake pedal to stop the vehicle running.
Exit the timer start: Timer start can be exited manually as follows:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition on. The LED and parking light will flash (4) times. The horn
chirps (4) times. Or
1. Press the button twice to remote start the vehicle. As soon as the vehicle is
running and the parking light have turned on or flashing.
2. Immediately depress the button then press and hold the button
for 2 seconds. (or depresses + buttons, if you program +
buttons = Start / Stop button.) The parking light will flash (4) times. The
siren or horn chirps (4) times. The vehicle is no longer programmed to
start automatically.
F. TEMPERATURE CHECK (OPTIONAL)
If you installed the optional temperature sensor, you can
monitor, through the LCD screen, the present indoor
temperature of the passenger compartment before cooling or
heating your vehicle.
Press the transmitter buttons first, within 3 seconds
press the ( ) button, the in-door temperature will be
shown on the LCD screen. This reading may be higher than
actual ambient temperature due to the greenhouse and is
relative only the inside vehicle temperature.
G. TO TURN OFF THE REMOTE START:
When the engine is running (by remote start), if you want to
stop it,
1. Press button once on the remote transmitter under
remote start mode.
2. Move the optional remote start enable toggle switch to OFF
position. (If installed)
3. Press the brake pedal The vehicle will shut down and turn off
the parking light
to indicate engine stopped.
H. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exist while the system is operating, the
engine will not start or will shut down immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. Engine is over-revved. {“Tachometer checking type” only}