Auto Page RS-860 lcd User Manual

Page 17

1. Press and hold the

button for 3 second. The alarm

will immediately sound.

2. During panic mode, the normal function of this

transmitter button will be disabled. The transmitter

and

buttons can be used to lock and unlock the

door (if the option is installed), however once the

button is pressed, the vehicle’s starter disable device,
(where installed) will be disengaged allowing the
vehicle to start.

3. To stop the alarm, press and hold the transmitter

button on the

transmitter again for 3 seconds. Also if any transmitter button other than

button is pressed and released, the panic mode will be turned off

immediately.

If the button is not pressed, the alarm will automatically stop after 30
seconds.

N. TRIGGER THE SYSTEM

When armed, your vehicle is protected as follows:

1. Light impact will trigger the warn-away signal.
2. Heavy impacts / Doors open / Hood open / Trunk open / Turning on the

ignition key will trigger the programmed sequence.

The starter disable relay (if installed) prevents the vehicle’s starter from
cranking. The siren, horn, parking lights, and dome light will turn on to alerting
of an intrusion for 30 seconds. Then it will stop and automatic reset and re-arm.
If the one of sensors or detectors still active, the alarm system will sound a
maximum of 3 times of 30 seconds cycles.

Door Trigger

Trunk/Hood Trigger

Warn-away Trigger

Shock Sensor Trigger

Ignition Trigger

CLEAR THE FLASH ICON AND MELODY SOUND: While
triggering the alarm the LCD screen will alert user through

melody sound and flashing trigger icon, press the

button 3 times within 3 seconds will clear the flash icon and
stop melody sound on the LCD screen transmitter.
STOP THE MELODY SOUND ONLY: While triggering the
alarm the LCD screen will alert user through melody sound
and flashing trigger icon, press any button on the LCD
remote transmitter to stop melody sound only

NOISE ABATEMENT CIRCUIT: You system has “Noise Abatement Circuit”. It
prevents annoying repetitive trigger sequences due to faulty door pin switches
or environmental condition such as thunder, jackhammers airport noise, etc.
Here’s how “Noise Abatement Circuit” works: The alarm triggers 3 times. Each
time, the same sensor or switch is triggering the alarm. “Noise Abatement