AmpliVox SW1234 - Manual (Page 3)

3
SPECIFICATIONS
Enclosure: Sealed Type / Rotational Molded
Rated Power Output 50 W Dynamic
AC Power 110-220 Auto sensing, 50/60 Hz,
Wireless Range Up to 300 Feet
UHF Wireless Frequency 584 - 608 MHz
Frequency Response: 100Hz to 12Khz
Sensitivity 96dB
Line output: Buffered, 600 ohm, 1/4in.jack (pre fader)
Phantom Power Input Powers Electret condenser microphones
Sensitivity for rated output:
Balanced Microphone -58 dBV (1.25 mVrms)
Balanced Line -15 dBV (175 mVrms)
Unbalanced Line
-20 dBV (100 mVrms)
Unbalanced input: Hi-Z, Neutrik combo - 1/4in.
Balanced Input: Lo-Z, Neutrik combo XLR
Weight: 4.5 lbs.
Dimensions (HWD ): 17 in. H x 3.4 in. W x 5.0 in. D
Warranty 6 years Electronics; 1 year on
Remote, Microphones, Cassette
Player, CD Player, Digital Player
and Rechargeable Batteries.
 Take care in selecting volume level, and speaker placement so that acoustic feedback (howling and screeching) will
be avoided.
 Please note the pickup patterns of the handheld microphone selected: Omnidirectional microphones pick up sound
equally from all directions and are prone to feedback if not used carefully. Unidirectional microphones are more re-
sistant to feedback, but pick up sound sources best that are directly in front of the microphone.
 Also, microphones that are farther from the sound source, such as lavaliers, require more acoustic gain and thus
are also more prone to feedback than close-source microphones such as handheld or headset microphones that
are used close to the mouth.
Mounting Speaker Bracket
 Slots have been provided on mounting bracket that will
accommodate 10-24 machine screws or wood screws
(not provided).
 Make sure that mounting surface will hold weight of
speaker.
Mounting Speaker to Bracket
 Locate the two speaker mounting knobs and washers.
 Insert one washer over stud of knob and screw part way
into the insert on the side of speaker. Repeat for other
side.
 Take speaker and align these two knobs with the slots in
the bracket.
 Position washer so that it is in-between the bracket and
bottom of knob.
 Slide into slot, position, and tighten both knobs.
SPEAKER BRACKET
MICROPHONES