beautypg.com

Speaker bracket, Troubleshooting guide – AmpliVox SW1230 User Manual

Page 3

background image

3

Mounting Speaker Bracket

·

Slots have been provided on mounting bracket that will
accommodate 10-24 machine screws or wood screws
(not provided).

·

Make sure that mounting surface will hold weight of
speaker.

Mounting Speaker to Bracket

·

Locate the two speaker mounting knobs and washers.

·

Insert one washer over stud of knob and screw part way
into the insert on the side of speaker. Repeat for other
side.

·

Take speaker and align these two knobs with the slots in
the bracket.

·

Position washer so that it is in-between the bracket and
bottom of knob.

·

Slide into slot, position, and tighten both knobs.

SPEAKER BRACKET

UNIT WILL NOT TURN ON

· Is unit plugged in?

`

SOUND IS DISTORTED

·

Turn down main volume

·

Turn down input source since the output of some devices may be too high

SOUND IS MUFFLED

·

Bass too high

FEEDBACK: ALOUD SQUEALING, SHRILL OR HOWLING SOUND THAT IS SELF GENERATED

·

Feedback occurs when a microphone is too close to the speaker or the microphone volume is too high, or the microphone is
pointed towards the speaker. It is also caused by sound reflecting off hard surfaces.

·

Reduce or eliminate Feedback by

- Pointing the microphone in a different direction
- Keeping the microphone BEHIND the speakers
- Turn down the volume levels

POWER IS ON, BUT NO SOUND

·

Check volume levels

·

If using wireless, be sure receiver(s) and/or transmitter battery is installed and/or is on

WIRELESS MICROPHONE SIGNAL IS WEAK

·

If microphone has batteries, check batteries

·

Check cables/connectors

WIRELESS MIC DOES NOT WORK

·

Check transmitter battery is alkaline and ensure transmitter is on.

·

Does green

“signal” LED light when transmitter is turned on?

·

Are the transmitter and receiver on the same channel? (1-16)

WIRELESS MIC CUTS IN AND OUT

·

Is unit visible (line of sight) from user? If not, move unit into view when using wireless microphone.

·

Does the green

“signal” LED go out when signal drops out? Check battery in transmitter.

TROUBLESHOOTING GUIDE

NEED HELP? Call 800-267-5486

This manual is related to the following products: