AmpliVox SW662 User Manual

Page 3

Battery Power

. The amp uses 10 " D " size Alkaline batteries

(not included); or the optional rechargeable Am-
pliVox NiCad Battery Pack (S-1465) and (S1460)
AC adapter -purchase separately (Fig 3).

2. The removable battery door on the back of the
amp is designed to stay closed until you need to
change the batteries. Slip a finger nail under it and
slide it out. (Fig 1)

3. Lift the battery holder out. The plastic dividers
between the batteries help prevent battery corro-
sion. (Fig 2)

4. Install 10 fresh Alkaline " D" size batteries. Be
sure to observe the polarity when putting batteries
in the battery compartment. The negative (flat)
ends go against the springs. (Fig 2) Carefully re-
place battery holder. Batteries should look like they
are standing up

DO NOT MIX BATTERY TYPES OR
ATTEMPT TO RECHARGE ALKA-
LINE BATTERIES. EQUIPMENT
DAMAGE, SAFETY HAZARD OR
FIRE COULD RESULT.

Note: The battery holder cable comes from the
factory already plugged into the connector. If it
comes loose, push it in securely. (Turn the plug
over if it doesn’t fit; it only fits one way.)

5. Slide door back into place.

6. If using the S-1465 NiCad Battery pack (Fig 3),
Plug AC Adapter/ Recharger power supply (S1460)
into the “DC IN” jack on front panel of the amp.
Plug into a working electrical outlet. Charge 24
hours for full charge before using.

Wireless Transmitter

The wireless headphone transmitter bodypack is
operated by 1 - "AA" alkaline battery. Before use,
install battery as shown (Fig. 4). Make certain the
battery is fully seated in its compartment so the
cover slides in place easily. Battery life with alkaline
batteries is approximately 8 hours of operating
time. When LED on top panel turns to RED the bat-
tery should be replaced immediately.

Fig 4

Fig 3

Fig 2

Fig 1

S-1465

S-1460

INSTALL BATTERIES

This manual is related to the following products:

SW660