ALLIED Vision Technologies Bigeye G-1100 Cool - Manual (Page 43)

AVT GigE Cameras Installation Manual V1.0.0
43
Implementing link aggregation
Percentage of single port GigE bandwidth ~ 84%, LAG is not required to operate
the GX1050 camera at 100 fps in Mono8.
Example 2:
GX1050C using YUV422 pixel format and outputting 100 fps
Bandwidth usage = 1024 x 1024 x 2 (2 byte for YUV422) x 100
~ 210 MBps
Percentage of single port GigE bandwidth ~ 168%, LAG is required to operate
the GX1050C at 100 fps using YUV422.
Configuring Link Aggregation
The GX camera connected to host using LAG requires two host Ethernet adapter
ports. Configure and optimize each Ethernet adapter port using steps outlined
in
Ethernet adapter configuration on page 17. The following steps describe the
setup of a link aggregate group.
[Windows 7, Intel PT]
– Start, Control Panel
– Hardware and Sound
– Device Manager
– Network Adapter
– Right-click Adapter device name
– Properties
– Teaming tab
– Select Team the adapter with other
adapters
– Click New Team
– The New Team Wizard window opens,
choose a team name and click Next
– Select the desired adapters corre-
sponding to the ports to be used by
the Prosilica GX camera, click Next
Figure 34: Team wizard adapter selection
Figure 33: Intel adapter properties
teaming tab