AMX MAX Servers - Manual (Page 75)

Rack Mounting MAX Servers
69 MAX Servers: HT Home Theater and MMS Multimedia Servers
2. Attach an Adapter Bar to the rear of each of the two Rack-Rail assemblies (FIG. 62). Once the
Adapter Bars have been attached to the front and rear of both Rack-Rail assemblies, the Rack-Rails
are ready to use.
Step 5: Mount the Rail/Bracket Assemblies Into the Equipment Rack
Once the Extension Brackets (or End Brackets) and Adapter Bars have been attached to the Rail
Assemblies, the Rail/Bracket Assemblies are ready to be mounted into the equipment rack.
Install the Rack-Rail assemblies into the equipment rack, aligning the holes on the Adapter Bars to the
mounting rails in the rack as shown in FIG. 63:
FIG. 61 Adapter Bar mounted to the front of the Rack-Rail assembly
FIG. 62 Mount the Adapter Bars to the Rail assemblies
FRONT VIEW REAR VIEW
Use the outside and center holes to mount
The bottom of the Adapter Bar sits flush against the tabs on the Rack-Rail assembly
the Rack-Rail w/ Adapter Bars to
the equipment rack
Use these holes to mount the Adapter
Bar to the Rack-Rails
Adapter Bar
Mounting rails on equipment rack
Rail Assembly
Adapter Bar
(rear)
(front)