CHIEF MFC Series - Manual (Page 8)

MFC, PFC Series Installation Instructions
8
Attaching Display to Cart
WARNING: EXCEEDING MAXIMUM WEIGHT CAPACITY
MAY LEAD TO SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! It is the installer’s responsibility
to ensure the total amount of weight placed on the cart does
not exceed 125 lbs (56.70 kg) for the MFC, and 200 lbs
(90.72 kg) for the PFC.
CAUTION: Before attaching display to cart set the brakes
on the back wheels by pressing down on the tab. (See
Figure 8)
Figure 8
4. Attach a PSBU or MSBU interface bracket to the display
following the instructions included with the bracket.
5. While supporting both sides of display, align four mounting
buttons on display or interface bracket with four mounting
holes in head assembly. (See Figure 9) and (See Figure 10)
Figure 9
WARNING: DISPLAY MAY WEIGH IN EXCESS OF 40
LBS! Always use two people and proper lifting techniques
when installing or positioning display on cart.
6. Lower display into place listening for audible "click" to
ensure recessed area of mounting buttons are properly
seated in lower area of mounting holes. (See Figure 9) and
(See Figure 10)
WARNING: IMPROPER INSTALLATION CAN LEAD TO
CART OR DISPLAY FALLING CAUSING SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT!
Ensure mounting buttons are completely engaged in
mounting holes.
NOTE: Holes are provided in the faceplate for use with a
padlock or similar locking device, if desired. In addition,
the pin and nut may be removed from the upper holes
and moved to the lower holes for use as a more
permanent locking device. (See Figure 10)
Figure 10
Press down to
set brakes
5
6
5
6
May remove
pin and nut and
move to lower holes
A padlock or bolt
may be placed
through latch holes