CHIEF PPC-2000 - Manual (Page 4)

Instruction Manual Plasma Presenters Cart
3
ASSEMBLE CART
Numbers in ( ) refer to parts shown in Figure 1 and
Figure 2. Assemble cart as follows:
1. Place base (10) upside down and thread two locking
casters and two regular casters (60) into base
(see Figure 3).
2. Place base upright on casters. Install right leg (20) and
left leg (30), making sure the mounting tabs face inward
(see Figure 4). Secure legs using two 1/4” fender wash-
ers (80), two lock washers (81), and two
1/4-20X5/8” screws (90).
3. Using eight 1/4-20X5/8” screws (90) and 1/4-20 Nylock
nuts (70), secure each side bracket (82) to the mounting
head (40) (see Figure 5).
4. Using six 1/4-20X5/8” screws (90) secure the face plate
(50) to the side brackets (82) (see Figure 5).
5. Using four 1/4-20X5/8” buttonhead cap screws, two per
side, secure the mounting head (40) to the top of the legs
of the cart (see Figure 7).
6. Install cap plugs in base (see Figure 4) and on top of
each leg (see Figure 6).
Locking Casters
Casters
Figure 3. Install Casters
4 Nylock Nuts
1/4-20X5/8”Screws
Figure 5. Face Plate and
Mounting Head
Figure 4. Install Legs
1/4-20X5/8”
Screw
1/4” fender
washer -
Select hole pattern for
desired height adjustment
Cap Plug
1/4-20X1/2”Screws
Figure 6. Install Mounting Head
and Cap Plugs