CHIEF MPT6000 - Manual (Page 5)

Installation Instructions MPT6000
5
Assembly And Installation
Mounting to a Wood Stud Wall
NOTE: The MPT6000 can be mounted to two 16" wood studs
or a single wood stud.
1. Using swing arm tilt mount (A) as a template, mark two or
four holes at desired mounting location. (See Figure 1)
2. Drill two or four 7/32" holes at marked locations. (See Figure
1)
3. Install two or four 5/16 x 2 1/2" hex head lag bolts (C)
through two or four 5/16" washers (E), swing arm tilt mount
(A) and into drilled holes on wall. (See Figure 1)
WARNING: ELECTRICAL SHOCK HAZARD! CUTTING
OR DRILLING INTO ELECTRICAL CORDS OR CABLES
CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY!
ALWAYS make certain area behind mounting surface is free
of electrical wires and cables before drilling or installing
fasteners.
WARNING: EXPLOSION AND FIRE HAZARD! CUTTING
OR DRILLING INTO GAS PLUMBING CAN CAUSE DEATH
OR SERIOUS PERSONAL INJURY! ALWAYS make certain
area behind mounting surface is free of gas, water, waste, or
any other plumbing before cutting, drilling, or installing
fasteners.
Figure 1
1
2
X2
X2
3
Single Stud
Dual Stud
(A)
(C) x 2
(E) x 2
(C) x 4
(E) x 4
1
2 X4
(A) 3
X4