Asus Barebone System A7VT400 - Manual (Page 31)

2 - 1 5 2 - 1 5 2 - 1 5 2 - 1 5 2 - 1 5 A S U S T e r m i n a t o r 1 A 7 V T 4 0 0 A S U S T e r m i n a t o r 1 A 7 V T 4 0 0 A S U S T e r m i n a t o r 1 A 7 V T 4 0 0 A S U S T e r m i n a t o r 1 A 7 V T 4 0 0 A S U S T e r m i n a t o r 1 A 7 V T 4 0 0
2.9 Installing a CD-ROM drive
A CD-ROM drive is an optional item in this barebone system. Refer to the
instructions in this section if you acquired a model without a CD-ROM.
To install a CD-ROM drive:
1. Place the chassis upright.
2. Insert the CD-ROM drive into
the upper 5.25-inch drive bay.
C D - R O M s c r e w s C D - R O M s c r e w s C D - R O M s c r e w s C D - R O M s c r e w s C D - R O M s c r e w s
5 . 2 5 - i n c h d r i v e b a y 5 . 2 5 - i n c h d r i v e b a y 5 . 2 5 - i n c h d r i v e b a y 5 . 2 5 - i n c h d r i v e b a y 5 . 2 5 - i n c h d r i v e b a y
3. Carefully push the CD-ROM
drive into the bay until its
screw holes align with the
holes on the bay as shown.
4. Secure the CD-ROM with two
screws on each side of the
bay.