beautypg.com

Autostart CT-3360 User Manual

Page 3

background image

CT-3360 User Guide

P. 3

Remaining in Ready Mode

Once the vehicle is in Ready Mode you can start and stop the vehicle at wish. However, if

any one of the following events occurs, the vehicle will exit Ready Mode – thus eliminating

the remote start option until Ready Mode is restored:

Door opened;

Hood opened;

Brakes pressed;

Parking Brake disengaged;

Key turned to the

IGNITION ON (RUN)

position.

Should any of the above occur, Ready Mode will be cancelled.
Note: The unit will notify the user that it has exited Ready Mode by giving three slow flashes

of the vehicle’s Parking Lights.

Remote-Starting

Press the

START/STOP

button for approx. 1 second. The parking lights will come ON, informing

you that the unit has received your signal. Approx. 5 seconds later, the engine will start. The

Parking Lights will remain ON during the pre-programmed run time.

If the vehicle doesn’t start the first time, the system will shut down, wait a few seconds, and

try to start the engine again. It will try to start the engine 3 times before giving up.

Vehicle Presets

Heater and Heated Seat

When leaving the vehicle it is recommended to preset the accessory controls in preparation

for the next remote start. Settings for the blower motor (fan), front and rear, as well as

heated seats (if equipped) should not be left on

HIGH

. It is recommended to leave the settings

on

LOW

or

MEDIUM

instead.

Windshield Wipers, Radio and Headlights

Certain vehicles require the radio and / or windshield wiper and / or headlight circuits to

become energized while running under remote start. When leaving the vehicle you must

ensure that the windshield wiper and headlight switches are

OFF

. Leaving the headlight

switch

O N

on certain types of vehicles could cause them to remain

ON

even after the remote

starter shuts down, resulting in a dead battery.

Driving Off

With the vehicle running under remote control, press the

UNLOCK

button to

DISARM

and

UNLOCK

the doors (if installed). Enter the vehicle and do the following:

Turn the ignition key to the

IGNITION ON (RUN)

position.

Press the brakes to disengage the remote starter unit.

You are now ready to drive off.

Caution: do not turn the key to the

CRANK

position with the engine running. This will cause

the starter motor to re-engage, unless your vehicle is equipped with the Start Kill / Anti-

Grind Feature (Optional).

Idle Mode

This feature allows the user to engage the remote starter to take over the vehicle while it is

already running with the key in the

IGNITION

switch. The vehicle will keep running for the pre-

programmed run time, or until it is shut down by remote.

Caution: Do not leave children or pets unattended in a car running in Idle Mode.

To activate Idle Mode: