CHIEF PSS Series - Manual (Page 7)

Installation Instructions PSS2000
7
Stand Adjustment
Adjusting Display Height
CAUTION: DO NOT ALLOW DISPLAY TO DROP TO
BOTTOM OF STAND. Displays are fragile and may be
damaged.
1. Hold display in place and loosen the four height adjustment
screws. (See Figure 2)
2. Position display to the desired height.
3. Tighten the four height adjustment screws. (See Figure 2)
Adjusting Stand Tension
1. Check swivel tension while display is attached to the stand.
2. If tension adjustment is necessary, slightly tighten or loosen
adjustment screws on bottom of PSS2000. (See Figure 6)
Figure 6
Adjusting Swivel Stops
1. Decide the amount of desired stand swivel (15°, 25° or 35°).
2. Insert a 10-24 x 1/2" screw (not provided) in one of the three
swivel stop holes in the stand base. (See Figure 7)
Figure 7
Adjusting Display Roll
1. Loosen upper and lower roll adjustment nuts.(See Figure 8)
2. Level display.
3. TIghten roll adjustment nuts.
Figure 8
Cable Routing and Management
WARNING: ELECTRICAL SHOCK HAZARD! Improper
routing can lead to wires or cables being damaged. Make
certain display power cable is not routed through areas where
it can be pinched or cut.
1. Route display cables and wiring through cable management
hole in base. (See Figure 9)
NOTE: Cables may also be routed through a hole in the
mounting surface.
2. Connect wires and cables to display.
Figure 9
Swivel Tension
Adjustment Screws
Swivel Stop Holes
1
2
3
2
1