CHIEF JPP Series - Manual (Page 6)

JPP SERIES Installation Instructions
6
2. Align two screws in display back with upper mounting holes
in Centris cup and lower display until screws are seated in
lower area of teardrop mounting holes. (See Figure 4)
3. Install two more of the same screws through lower mounting
holes in Centris cup and into display back. (See Figure 4)
4. Tighten all hardware.
5. Route cables and wires to display.
Figure 4
ADJUSTMENTS
To adjust display Roll, Pitch, and YAW tension:
1. Disconnect all wires and cable from the display.
2. Remove two Lower screws securing display to Centris cup.
3. Loosen two Upper screws securing display.
4. Lift display upward and away from mount.
5. Using a hex head wrench, turn the tension adjustment
screw clockwise to increase tension, or counter-clockwise
to decrease tension. (See Figure 5)
6. Re-install display.
Figure 5
x 2
2
3
4