Hunter 99112 On/Off Control User Manual

Universal ceiling fan remote control, Installation wiring or or or, Fr om receiver

www.HunterFan.com

1.888.830.1326

Model #99112

Universal Ceiling Fan

Remote Control

Installation

Wiring

OFF

Remove the canopy. If uncertain
how to remove it, reference the fan’s
owner’s manual. With wiring exposed,
it may be helpful to note existing wire
connections or take a digital photo for
reference. Remove the wire connectors
that connect the wires from the outlet
box to the fan, leaving the grounding
wires connected.

CONNECT WIRES FROM RECEIVER TO FAN -Using the blue wire connectors connect the white wire from the
receiver (marked “common out”) to the white wire from fan. Connect the black wire from the receiver (marked
“fan out”) to the black wire from the fan. Connect the blue wire from the receiver (marked ”light out”) to the
blue wire (or possibly black with white stripe) from the fan.

Note: The red wire from the receiver has a pre-installed wire terminator. It will not be used.

If you’re uncertain about wire colors or connections, please contact a qualified electrician.

CONNECT WIRES FROM RECEIVER TO WIRES FROM OUTLET BOX - Using an orange wire connector connect
the black wire (ungrounded) from the ceiling to the black wire from the receiver (marked “live in”). Connect
the white wire (grounded) from the ceiling to the white wire from the receiver (marked “neutral in”).

AFTER ALL WIRES ARE CONNECTED and secured with wire connectors, re-install the canopy.

Before installing the
Universal Remote
Control, use the pull
chains to turn the light
ON. Be sure power is OFF
before proceeding with
installation.

Choose the hanging system that most closely resembles the one used by your fan and install the receiver and wire as directed.

Note: Some fans may have considerable excess lead wire. For easier canopy installation, cut the excess wire, leaving a minimum of 8” remaining. Re-strip the fan lead wires 1/2”. Place remaining excess
wire into the ceiling electrical box. The bracket and fan must remain properly grounded.

You may have installation issues if the fan is installed on an angled ceiling.

Ceiling

Plate

Receiver

Canopy

Receiver

Canopy

Ceiling

Bracket

Receiver

Fan Body

Cable Tie

For low profile fans, the receiver should

be secured to the hanger bracket with

a cable tie.

Receiver

Canopy

Turn the splices upward and push them carefully back through the hanger bracket

into the outlet box. Spread the wires apart, with the grounded wires on one side of

the outlet box and the ungrounded wires on the other side of the outlet box.

To avoid possible electrical shock, before installing or servicing your fan, disconnect the
power by turning off the circuit breakers to the outlet box and associated wall switch
location. If you cannot lock the circuit breakers in the off position, securely fasten a
prominent warning device, such as a tag, to the service panel.

RECEIVER

FRO

M CEILING

black (ungrounded)

white (grounded)

white (neutral in)

black (live in)

RECEIVER

white

black

blue

white (common out)

black (fan out)

blue (light out)

FROM FAN