AEG S94400CTX0 - Manual (Page 20)

Problem Possible cause Solution
The temperature in the
appliance is too low.
The temperature regulator is not
set correctly.
Set a higher temperature.
The temperature in the
appliance is too high.
The temperature regulator is not
set correctly.
Set a lower temperature.
The door is not closed correctly. Refer to "Closing the door".
The product temperature is too
high.
Let the product temperature de-
crease to room temperature be-
fore storage.
Many products are stored at the
same time.
Store less products at the same
time.
The temperature in the re-
frigerator is too high.
There is no cold air circulation in
the appliance.
Make sure that there is cold air
circulation in the appliance.
The temperature in the
freezer is too high.
Products are too near to each
other.
Store products so that there is
cold air circulation.
Technical problems electrical malfunction Contact Customer Service De-
partment
Upper or lower square is
shown in the temperature
Display.
An error has occurred in meas-
uring the temperature
Call your service representative
(the cooling system will continue
to keep food products cold, but
temperature adjustment will not
be possible).
dEMo appears on the Dis-
play.
The appliance is in demonstra-
tion mode (dEMo) .
Keep pressed approximately 10
sec. the OK button since a long
sound of buzzer is heard and the
Display shut off for a short while:
appliance start works regularly.
Replacing the lamp
CAUTION!
Disconnect the plug from the mains socket.
1. Press on the rear hook of the lamp cover by a
screwdriver and at the same time pull and
rotate the cover in the direction of the arrow.
2. Replace the lamp with one of the same pow-
er and specifically designed for household
appliances. (the maximum power is shown on
the light bulb cover).
3. Install the lamp cover by fixing it into its
original position.
4. Connect the plug to the mains socket.
5. Open the door. Make sure that the light comes on.
1
2
20 What to do if…