Hunter 99134, 99135, 99136, 99138, 99140 Traditional 3-Light Fitter - Manual (Page 2)

MA015-01 • 12/31/13
1.888.830.1326
If you have problems installing or operating your light kit, do not return
this product to the dealer. Call our Consumer Affairs Hotline.
888-830-1326
READ AND SAVE THESE INSTRUCTIONS
This product conforms to UL Standard 507.
WARNINGS
TROUBLESHOOTING
Lights don’t come on.
• Make sure that the bulbs are properly installed.
• Make sure power switch is on.
• Pull the pull chain to make sure it is on.
• Check the circuit breaker to ensure the power is turned on.
• Check the pin connections in the light kit.
• Refer to the fan manual for locating the fan’s wiring. Verify that the
light and power wires are correctly connected to the ceiling and
the light kit.
CAUTIONS
ON
Turn
Pow
er
ONE YEAR WARRANTY
This product is warranted to the original purchaser by Casablanca
Fan Company/Hunter Fan Company against defects in material and
workmanship for one (1) year from date of purchase. During the
warranty period, we will repair or, at our option, replace a defective
product at no charge. For information on how to obtain service,
contact the Casablanca/Hunter Service Department by calling our
toll-free number at 888-830-1326. Damage to the product caused
by mishandling, improper installation or modification is not covered
by this warranty. This warranty is given in lieu of all other warranties
expressed or implied. Some states do not allow limitations of time
on an implied warranty, therefore the above limitations may not
apply in every case. This warranty states specific legal rights which
may vary from state to state.
Installing the pull chain pendant -
Attach the pull chain pendant to the
end of the short chains coming from the
switch housing and the light kit.
To turn lights on and off, pull the pull
chain pendant coming from the center
of the light kit.
Pull Chain
Pendant
Installing the shades - To install the
shade, first loosen the thumb screws.
Raise the shade to the light fixture.
Tighten all thumbscrews securely.
Installing the bulb - Install a bulb into each
socket. When necessary, replace bulbs with
bulbs of same type and wattage.
FOR BOTH ASSEMBLIES
Shade
(not included)
w.1 - To reduce the risk of fire, electrical shock, or personal injury, mount fan
directly from building structure and/or an outlet box marked acceptable for
fan support of 70 lbs. (31.8 kg) and use the mounting screws provided with the
outlet box.
w.2 - To avoid possible electrical shock, before installing or servicing your fan,
disconnect the power by turning off the circuit breakers to the outlet box and
associated wall switch location. If you cannot lock the circuit breakers in the
off position, securely fasten a prominent warning device, such as a tag, to the
service panel.
c.1 - All wiring must be in accordance with national and local electrical codes ANSI/
NFPA 70. If you are unfamiliar with wiring, use a qualified electrician.
Thumb Screw