Hunter 99148, 99150, 99159 Energy Star Low Profile Integrated Kit - Manual (Page 6)

MA020-01 • 03/05/14
1.888.830.1326
6
TYPE-B ASSEMBLY INSTRUCTIONS
Using the single pin connectors, connect
the black or blue wire from the fan to the
black wire from the light kit. Connect the
white wire from the fan to the white wire
from the light kit.
Feed the wires through the center hole in
the switch housing, the washer, and the
nut. Then install the switch housing by
twisting clockwise onto the threaded rod.
Install the washer and nut onto threaded
rod and tighten securely.
Lift the light kit assembly up so that the
screw holes in the lower switch housing
line up with the holes in the upper switch
housing. Install the switch housing
screws and tighten securely.
1
3
Switch
Housing
Screw
Wire
Connector
Switch
Housing
If your fan does not have pin
connectors on the wires coming from
the switch housing, install the wiring
harness provided. Using the provided
wire connectors connect the white
wire from the fan to the white wire
from the wire harness and connect the
black or blue wire from the fan to the
black wire from the wire harness.
Do not allow the light kit to hang
only by the wire connections!
2
4