Hunter 28791 46 Bixby - Manual (Page 9)

9
42481-01 • 12/15/11 • Hunter Fan Company
All wiring must be in accordance with national and local electrical
codes and ANSI/NFPA 70. If you are unfamiliar with wiring, use a
qualified electrician.
Wall switches are not included. Select an acceptable general-use
switch in accordance with national and local electrical codes.
4.1. Before attempting installation, make sure the power is still off.
4.2. To connect the wires, hold the bare metal leads together and
place a wire connector over them, then twist clockwise until
tight. For all these connections use the wire connectors provided.
4.3. Connect the bare or green ground wire (grounding) from the
ceiling to the green ground wire (grounding) from the ceiling
plate and the green ground wire (grounding) from the fan. If you
chose the low profile option, the green ground wire from the fan
can be found on the low profile washer.
4.4. Connect the white wire (grounded) from the ceiling to the white
wire (grounded) from the fan.
4.5. Connect the remaining wires as follows:
Dual Switch Wiring:
• The black wire (ungrounded) from the ceiling to the black
wire (ungrounded) from the fan
• The black wire with a white stripe (ungrounded) from the fan
to the wire (ungrounded) for the wall switch
Single Switch Wiring:
• The black wire (ungrounded) from the ceiling to the black
(ungrounded) and the black wire with a white stripe
(ungrounded) from the fan
CAUTION: Be sure no bare wire or wire strands are visible after
making connections.
4.6. Turn the splices upward and push them carefully back through
the ceiling plate into the outlet box.
4.7. Spread the wires apart, with the grounded wires on one side of
the outlet box and the ungrounded wires on the other side of
the outlet box.
Dual Switch Wiring
Single Switch Wiring
Wire
Connector
4 • Wiring the Fan