Hunter 28791 46 Bixby - Manual (Page 12)

12
42481-01 • 12/15/11 • Hunter Fan Company
7 • Completing Your Installation With a Multi Staked Light Fixture
Plug
Connector
Detail
WARNING: Use only the light fixture supplied with this fan model.
7-1. To attach the upper switch housing, partially install two #6-32 x
3/8” housing assembly screws into the switch housing mounting
plate.
7-2. Align the keyhole slots in the housing with the housing
assembly screws.
7-3. Turn the housing counterclockwise until the housing assembly
screws are firmly situated in the narrow end of the keyhole
slots. Install the remaining #6-32 x 3/8” screw into the housing.
Tighten all three screws firmly.
CAUTION: Make sure the upper switch housing is securely
attached to the switch housing mounting plate. Failure to properly
attach and tighten all three assembly screws could result in the switch
housing fixture falling.
7-4. To attach the lower switch housing, connect the upper plug
connector from the motor to the lower plug connector in the
lower switch housing assembly.
Note: Both plug connectors are polarized and will only fit
together one way. Make sure the connectors are properly
aligned before connecting them. Incorrect connection could
cause improper operation and damage to the product.
7-5. Place the lower switch housing assembly over the upper switch
housing. Align the side screw holes in the upper and lower
switch housings. Attach the lower switch housing to the upper
switch housing with three #6-32 x 3/8” housing assembly screws.
Steps 7-1 – 7-3
Housing
Assembly
Screw
Upper
Switch
Housing
Housing
Assembly Screw
Lower
Switch
Housing
Plug
Connector
Step 7-4